Need a specific job done rather than a full service?
Not sure what you need? Drop us a message — we'll advise you honestly.
Standard fitting
Fit replacement tyre
Swap a tyre on a standard wheel, re-using existing inner tube. New tube is an additional £5.
£15 per wheel
Fit new inner tube
Swap the inner tube on a standard wheel. Price includes new tube.
£20 per wheel
Fit new inner tube — hub geared bike
Hub-geared wheels require cable disconnection before removal — adds time. Price includes new tube.
£25 per wheel
Tubeless
Tubeless top-up
Top up your existing sealant. Includes sealant.
£15 per wheel
Tubeless puncture repair
Plug where the sealant hasn’t sealed. Sealant top-up included.
£20 per wheel
Tubeless conversion
Convert your wheel to a tubeless setup. If required, rim tape, valve and sealant are an additional £20.
£25 per wheel
Truing and building
Wheel true
Adjust your wobbly wheel to run true and straight. We adjust to ≤ 0.5 mm lateral, 1 mm radial, dish centred, tension within ±20% of that side’s average.
£20 per wheel
Spoke replacement and wheel true
Replace broken or damaged spokes, then re-true the whole wheel.
£35 per wheel
Spoke replacement and wheel true - tubeless
Replace broken or damaged spokes, re-true the whole wheel and then re-install new tubeless tape and sealant. Rim tape and sealant included in cost.
£55 per wheel
Wheel build
Build new wheel. Parts not included in price.
£90 per wheel
Hub servicing
Adjust cup and cone hub bearings
Dial in cup-and-cone bearing preload to eliminate play or binding.
£20 per wheel
Strip and re-grease cup and cone front hub
Full strip, clean, regrease and reassembly. Restores smooth bearing action.
£25 per wheel
Strip and re-grease cup and cone rear hub
As front hub, plus the freehub body and pawls are cleaned and lubed.
£45 per wheel
Sealed bearing replacement — front hub
Press out old cartridge bearings, press in new. Bearing cost not included.
£25 per wheel
Sealed bearing replacement — rear hub
As front, with additional freehub removal required.
£40 per wheel
Hub gear service
Internal gear hubs (Nexus, Alfine etc.) need periodic oil and adjustment.
£60 per wheel
Adjustment and cables
Gear adjustment
Gears indexed and limit screws set for crisp, reliable shifting.
£15
Gear inner cable replacement
New inner cable fitted and indexed. Outer housing extra if needed.
£20
Gear inner and outer cable replacement
New inner and outer cable fitted and gears indexed for the ultimate in crisp shifting.
£30
Mechs and shifters
Straighten rear derailleur hanger
A bent hanger is the most common cause of poor shifting. Quick fix, big difference.
£15
Fit rear derailleur hanger
Replace a damaged hanger and re-align the mech.
£20
Fit derailleur
Front or rear. Includes cable routing, indexing and limit adjustment.
£25
Fit gear shifter
New gear shifter, inner cable and gears indexed.
£25
Drivetrain components
Fit new pedals
Crank arm threads cleaned and fresh anti-seize paste applied.
£10
Fit chain
Size, fit and check compatibility with existing cassette.
£15
Fit cassette
Remove old cassette, fit new, check freehub body condition.
£20
Fit new chainring or chainset/crankset
Remove old and fit new chainrings or chainset/crankset. Bottom bracket condition checked as part of the job.
£25
Combined jobs
Fit chain + cassette
Both fitted and set up together — the usual pairing when a worn chain has taken the cassette with it.
£30
Fit chain + cassette + chainset/crankset
The full drivetrain refresh, fitted and indexed together.
£50
Fit full MTB groupset
Looking to upgrade your mountain bike groupset? Parts not included in price.
£95
Fit full road/gravel groupset
Looking to upgrade your road or gravel groupset? New bar tape fitted. Parts not included in price.
£120
Cable brakes
Cable brake adjustment
Pad alignment, cable tension and lever reach set for safe, even braking.
£15
Cable brake block replacement
New rim-brake blocks fitted and toed-in. Blocks not included.
£15 per wheel
Fit rim brake calliper
Mount, cable, align and adjust a new rim brake calliper.
£20
Brake inner cable replacement
New inner cable fitted and set up.
£20
Brake inner and outer cable replacement
Full new cable and housing, fitted and set up.
£30
Hydraulic brakes
Brake pad replacement
New pads fitted and aligned. Pads not included.
£15 per wheel
Hydraulic brake clean
Remove and clean calliper, pads and rotor to clear contamination that causes squealing and weak braking. Pads de-glazed and rotor cleaned; badly contaminated pads may need replacing.
£20 each
Hydraulic brake bleed
Full fluid flush and bleed for firm, consistent lever feel.
£35 each
Fit hydraulic brake lever
Mount and route a new lever. Includes bleed.
£40
Fit hydraulic brake calliper
Mount, connect and align a new calliper. Includes bleed.
£40
Replace grips
Remove old flat bar grips (lock-on or glued) and fit new ones.
£10
Replace stem
Swap the stem for a new one.
£10
Replace flat handlebars
Remove bars and fit new ones, and refit controls. Cables re-routed if needed.
£20
Replace bar tape
Full re-wrap with neat, even tension. Bar plugs included.
£20
Replace drop handlebars
Remove old and fit new bars, set up levers, including a fresh bar-tape wrap.
£40
Frame and forks
Frame alignment check
Check dropouts and frame are true. Essential after a crash or if handling feels off.
£10
Steerer tube resize
Cut steerer to length and reface. Required when fitting a new fork or changing stack height.
£35
Fork fitting
Remove old fork, fit new, set headset preload and bar height.
£40
Headset
Adjust loose bearing headset
Bearing preload adjustment to remove play or stiffness. No strip-down needed.
£10
Replace headset bearings
Fit new cartridge bearings to an existing headset.
£20
Replace complete threaded headset
Remove and replace a full threaded headset unit.
£25
Strip and re-grease headset
Full strip, clean, regrease and reassembly. Eliminates creaks and restores smooth steering.
£35
Replace complete press-fit headset
Requires careful extraction and pressing to avoid frame damage. More involved than threaded.
£40
Bottom bracket
Bottom bracket adjustment
Preload adjustment on cup-and-cone style BBs to remove play or drag, no strip-down.
£15
Fit threaded bottom bracket
Remove old, chase threads / face shell, fit and torque new unit.
£25
Bottom bracket service
Full strip, degrease, regrease and reassembly. Extends life significantly.
£35
Fit press-fit bottom bracket
Requires careful extraction and pressing to avoid frame damage. More involved than threaded.
£40
Seatpost & saddle
Replace seatpost clamp
Fit a new clamp and set saddle height securely.
£10
Fit external dropper post
External cable routing. Includes lever mount and travel adjustment.
£35
Fit internal dropper post
Internal routing takes considerably longer — frame access, cable threading, full setup.
£50
Suspension
Fork lower leg service
Drain old oil, clean stanchions and seals, refill. Restores smooth action and protects the internals.
£40
Shock basic air can service
Remove air can, clean and re-lube seals, recharge to rider pressure.
£40
Replace pivot bearings
Old bearings pressed out of frame pivots, housings cleaned and re-greased, new bearings fitted. Labour-intensive; bearings not included.
£180
Bike builds
Build from box — road / hybrid / gravel
Assemble and safety-check a boxed or online-bought bike. Gears and brakes set up, everything torqued to spec and test ridden.
£75
Build from box — mountain bike
Assemble and safety-check a boxed or online-bought MTB, plus suspension set to your weight and tubeless setup.
£90
Build child's bike / BMX
Assemble and safety-check a boxed child's bike or BMX, set up for safe riding.
£45
Cleaning
Bike wash & re-lube
Full wash, dry and drivetrain re-lube. A clean drivetrain shifts better and lasts longer.
£25
Accessory fitting
Fit mudguards
Full set fitted and aligned to clear the tyres.
£15
Fit pannier rack
Rack mounted securely and levelled.
£15
Fit lights (set)
Front and rear lights mounted and positioned.
£10
Fit bottle cage(s)
One or two cages fitted to the frame bosses.
£8
Fit computer / GPS mount
Mount fitted; wired sensors set up and paired where needed.
£15
Fit child seat
Child seat mounted and safety-checked.
£20
Fit stabilisers
Stabilisers fitted and set level for a new rider.
£10
Fit kickstand
Kickstand fitted and adjusted to length.
£8
Others
Crash / insurance damage report
Detailed written inspection after a crash — frame, forks, wheels, drivetrain and brakes checked for damage, with a report suitable for an insurance claim.
£55
Workshop labour
For any job not listed here. Billed in 15-minute increments; always quoted and agreed before we start.
£60 per hour
All prices are labour only, unless explicitly stated otherwise; parts are quoted separately and you’re welcome to supply your own.